10-01-2019, 07:37 PM
Can custom G-code be added to the end of prints? On my FDM printer I use the code below to beep 3 times to let me know a prints finished.
Also thinking about adding some kind of Z shake routine at the end of prints to get some resin drips off. would that be possible?
Also thinking about adding some kind of Z shake routine at the end of prints to get some resin drips off. would that be possible?
Code:
;Beep Beep Beep
M300 S500 P250
M300 S0 P500
M300 S500 P250
M300 S0 P500
M300 S500 P250
M300 S0 P500