01-02-2025, 06:11 AM
Hi all
Relatively new to resin printing, having acquired a Saturn a little while ago. Having played around and worked out how things work, I am now going through the calibration processes.... Having printed some calibration prints from J3DTech, I believe I need to amend the Z-axis to 0.2mm.
Having done some reading and digging on this forum, I believe I need to add the GCODE M8084 Z0.2 to the Saturn Machine Parameters GCODE file.
- Does this sound correct?
The main question is, how do I then upload the file to the printer? Do I just put it onto a USB stick and select the file, or does it need to be compiled somehow? If so, how?
Or there an aleternat9ive to this, using GCODE in Chitubox to set the offset?
I figured out how to display the GCODE in Chitubox Basic 2.1, and can see the G28 Z0 command in there, but I assume if the firmware is modified with GCODE above, then G28 will be correctly set at 0.2mm?
Thanks for any pointers!
Daz
Relatively new to resin printing, having acquired a Saturn a little while ago. Having played around and worked out how things work, I am now going through the calibration processes.... Having printed some calibration prints from J3DTech, I believe I need to amend the Z-axis to 0.2mm.
Having done some reading and digging on this forum, I believe I need to add the GCODE M8084 Z0.2 to the Saturn Machine Parameters GCODE file.
- Does this sound correct?
The main question is, how do I then upload the file to the printer? Do I just put it onto a USB stick and select the file, or does it need to be compiled somehow? If so, how?
Or there an aleternat9ive to this, using GCODE in Chitubox to set the offset?
I figured out how to display the GCODE in Chitubox Basic 2.1, and can see the G28 Z0 command in there, but I assume if the firmware is modified with GCODE above, then G28 will be correctly set at 0.2mm?
Thanks for any pointers!
Daz