11-30-2021, 08:37 PM
I followed the steps as well, and went from 18.8mm and am now corrected to 20mm. However my cube x and y lengths have always been 22mm, both before correcting the z offset and after. Oddly, this change has done nothing (except for happy mr. cube's z height) since my prints are still "squished" on the z axis. Maybe parts of the print are a little better close to the build plate, but for most things raised on supports they appear to have the exact same amount of problem I've always had, which is around 8-10% z axis squishing. I'm assuming this has to do with whatever is causing the 10% increase in x and y sizes.
Any advice?
Any advice?