10-20-2019, 10:56 AM
(This post was last modified: 10-20-2019, 10:57 AM by Blackbird2016.)
Reason is some play/air in the z-axis with springs and such in all the mechanics it seems.
Elegoo is providing modified z-axis-motors on request on goodwill and very friendly.
Workaround!
Change the settings in the machinesettings gcode https://drucktipps3d.de/wp-content/uploa...eset.gcode
from M8083 from I0 to I1 to make the set-zero-button working.
Level with the level-button and still loose platform.
Lower the platform 1 or 2 millimeters and level your plate.
Lift the platform some 2 millimeters and lower it agai in 0,1 mm steps
Set zero once you get your desired zero, paper barely moving.
Remove G28 Z0 in the chitubox Gcode settings.
For that navigate into the istallation folder and find the elegoo settings and set show gcode from 0 to 1.
Delete your printer and read it in anew. Then the gcode settings will be shown...
Elegoo is providing modified z-axis-motors on request on goodwill and very friendly.
Workaround!
Change the settings in the machinesettings gcode https://drucktipps3d.de/wp-content/uploa...eset.gcode
from M8083 from I0 to I1 to make the set-zero-button working.
Level with the level-button and still loose platform.
Lower the platform 1 or 2 millimeters and level your plate.
Lift the platform some 2 millimeters and lower it agai in 0,1 mm steps
Set zero once you get your desired zero, paper barely moving.
Remove G28 Z0 in the chitubox Gcode settings.
For that navigate into the istallation folder and find the elegoo settings and set show gcode from 0 to 1.
Delete your printer and read it in anew. Then the gcode settings will be shown...