10-29-2019, 01:00 PM
(This post was last modified: 10-29-2019, 01:03 PM by oeildefaucon.)
(10-23-2019, 01:39 PM)To Polymerchecher
Hello,I am new and french on this forum and have a printer for 2 weeks and always problems with Z axis
the difference is 1.1 mm which misses.I try many ways,
I put ballbearing on the top of the Z axisI built your system and try without succes.
Probably don\t understand the correct processmy english not wonderful
But can you explain how you calibrate your screw with the spring on your system ?
is it before or after your explanation to calibrateWhen the printer makes the first layer,
must be the red led on or off ?
Hope you can understand my request
This machine seems good for details but this problem of first deleted layers is very pity
Thank by advance'
pid='556 Wrote: Traduit avec www.DeepL.com/Translator