11-03-2019, 10:33 AM
(This post was last modified: 11-03-2019, 10:37 AM by Blackbird2016.)
(11-03-2019, 08:10 AM)OscarW Wrote: The problem is mechanic and describe in this blogYes, you are all correct!
https://blog.honzamrazek.cz/2019/09/test...t-finally/
The problem is mechanic.
You can get in contact with elegoo here https://www.elegoo.com/contact-us/
The workaround I described on page two here works pretty well.
Make the "set-zero-button" work as described with the machine-settings-gcode which is linked there
and remove G28Z0 from the gcode section in chitubox. For that you need
to go into the Chitubox installation folder and modify in the elegomars settings "gcode visible" from 0 to 1
Then use the level button and go DOWN for two more milimeters (https://www.thingiverse.com/thing:3911297 could be of help), fasten your plate only then.
Move one milimeter up and then in 0,1steps down again until the plate barely grips the paper. Set zero.
My parts ever since are spot on!