Thread Rating:
  • 3 Vote(s) - 5 Average
Modified Gcode to only run the cooling fan while the printer is running
#6
(08-16-2019, 09:34 AM)blubarist Wrote:
(08-16-2019, 06:01 AM)f15sim Wrote: Would it be possible to post a version of the gcode file that had the comments in English? Smile

Tnx.
You can look at the original file from Elegoo.

The modification needed is this:
M8030 I-1
To:
M8030 I-2

Can the M code just be updated to the g-code prefix section in ChiTuBox as well?  (I would assume so, but...)

tnx.

g.
Reply


Messages In This Thread
RE: Modified Gcode to only run the cooling fan while the printer is running - by f15sim - 08-16-2019, 09:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)