07-02-2020, 02:27 PM
(07-02-2020, 02:19 PM)ANTARCHY Wrote: I torqued down on those bolts as hard as I could. I set the home 10mm above the LCD to eliminate that as a possibility. The set home doesn't set home.maybe we need videos of it happening
the way I level is
1. Loosen the bolts on the build plate
2. Put paper over the lcd
3. hit the home button
4. Let it level itself ( it will push the plate in the housing since its spring loaded)
5. after its home and resting on the paper, tighten the bolts on the build plate
6. Raise the plate 90-100mm to put the resin vat in and print.
is that the same steps you are following?