Has anyone experienced noise when moving the z axis during printing? When I go up and down manually there is no noise.
Es un ruido similar a un salto, y solo ocurre en una sección del huso
Gracias por su apoyo
(02-09-2020, 05:58 AM)jorge polo Wrote: ¿Alguien ha experimentado ruido al mover el eje z durante la impresión? Cuando subo y bajo manualmente no hay ruido.
Es un ruido similar a un salto, y solo ocurre en una sección del huso
Gracias por su apoyo
thanks for your quick response. I see that I have the same configuration as the one you attached. I am too new to understand what you say about eliminating the actual FEP layer. Can you tell me that I have to change? Thank you so much for your patience