|
Problem with an Elegoo Mars
|
02-13-2020, 01:16 PM
Hi there,
I have a problem with an Elegoo Mars the imagesetter (UV-Light) unit lights up when the printer is switched on, is this normal?
02-14-2020, 07:22 AM
no, that is not normal.
which actual version of the firmware is on the printer? made any changes on the firmware?
02-15-2020, 02:40 AM
02-15-2020, 03:18 AM
with Ver.: 4.3.2_LCDF = Houston we have a problem ;-) (no documents and downloads about this firmware - it's the new one for the new mainboard)
you should contact Elegoo-support - if you are able to open the printer, you can try a reset of the mainboard - see picture please give a feedback, if that worked
02-15-2020, 09:45 AM
(This post was last modified: 02-15-2020, 09:46 AM by Interceptor.)
(02-15-2020, 03:18 AM)fromFDMtoSLA Wrote: with Ver.: 4.3.2_LCDF = Houston we have a problem ;-) (no documents and downloads about this firmware - it's the new one for the new mainboard) I have try a reset, no results
02-15-2020, 09:59 AM
looks like the driver for the UV-Leds is gone (MosFet on the back of the pcb)
i think, it's better to contact Elegoo-support to get a new mainboard
02-15-2020, 10:36 AM
same effect with a new mainboard ? = strange
(no ideas from my side)
02-15-2020, 12:48 PM
can you measure the "LED-out" (voltage) from the mainboard with a multimeter?
if it's around zero, check again after starting the exposure-test. |
|
« Next Oldest | Next Newest »
|
