03-01-2020, 05:01 AM
Hi
So I was having an issue with my printer where the build platform would not rise correctly, sometimes in judders and starts otherwise simply not moving at all
I cleaned the mechanisms twice, the screw the platform moves up and disassembled the build plate and it's interior screws. I am confident it is not an issue with grease on the screw.
Now a new issue has presented while I was attempting to troubleshoot and when the build platform lowers it does not realise it has reached the LCD screen and continues to try and lower, I have leveled the base and it has not helped. I'm unsure if I now have two issues one with the motor not being strong enough and also the sensor to detect z=0 also not functioning
Any advice is appreciated if anyone has had any similar issues
Thanks for any replies
So I was having an issue with my printer where the build platform would not rise correctly, sometimes in judders and starts otherwise simply not moving at all
I cleaned the mechanisms twice, the screw the platform moves up and disassembled the build plate and it's interior screws. I am confident it is not an issue with grease on the screw.
Now a new issue has presented while I was attempting to troubleshoot and when the build platform lowers it does not realise it has reached the LCD screen and continues to try and lower, I have leveled the base and it has not helped. I'm unsure if I now have two issues one with the motor not being strong enough and also the sensor to detect z=0 also not functioning
Any advice is appreciated if anyone has had any similar issues
Thanks for any replies