I was so looking forward to this day.
I have been part of the 3D printing community since the start. I own and almost daily operate my TAZ 6, Prusa Mk3S, Creator Pro ( mainly ABS) and Form 2.
Everyone raved about the MARS.
I received mine today, Very well packed. Better than any other printer. Followed the calibration instruction, used the new water washable resin and ...nothing !
After 2 hours into a 3 hour print no adhesion !!
WTF ???
Re-calibrate and re-run the stock print. No Adhesion !
Try a third time and the printer stops, following a bad smell (electrical).
Amazon return and back it goes.
So disappointed ! Why would this even happen ?
I have to say that i am now waiting for the Epax x1 to come back in stock to try them.
Elegoo is done for me !
Very Disappointed !
I have been part of the 3D printing community since the start. I own and almost daily operate my TAZ 6, Prusa Mk3S, Creator Pro ( mainly ABS) and Form 2.
Everyone raved about the MARS.
I received mine today, Very well packed. Better than any other printer. Followed the calibration instruction, used the new water washable resin and ...nothing !
After 2 hours into a 3 hour print no adhesion !!
WTF ???
Re-calibrate and re-run the stock print. No Adhesion !
Try a third time and the printer stops, following a bad smell (electrical).
Amazon return and back it goes.
So disappointed ! Why would this even happen ?
I have to say that i am now waiting for the Epax x1 to come back in stock to try them.
Elegoo is done for me !
Very Disappointed !