03-07-2020, 05:25 AM
Hi folks. I've had this problem a few times with my new Mars Pro. It doesn't happen with everything I print, but has happened a few times.
This is the same STL sliced three times, two different exposures at 0.05mm, and one at 0.025mm.
I also have a picture of it happening on a larger object.
Unfortunately, due to the completely undocumented new file format, I can't preview the sliced file, or try any other slicer than Chitubox.
This is the same STL sliced three times, two different exposures at 0.05mm, and one at 0.025mm.
I also have a picture of it happening on a larger object.
Unfortunately, due to the completely undocumented new file format, I can't preview the sliced file, or try any other slicer than Chitubox.