LCD error code: T_100 L_10

[seafreak62]

All,

Has anyone seen this one.

Elegoo Mars (09)
System: ChiTu L 5.5 Series
Version: V4.2.20.3_LCDE/1440x2560 /F2.9

After loading up a model and hitting the print button I received:

LCD error code: T_100 L_10. please try to continue printing.  Confirm

The print bed will move up like it was paused and the only thing you can do is hit the play button again, receive the same error or go back.

Tried multiple models just to ensure I didn't get a back slice.

About the only thing I can find is in relation to the EPAX and the Photon and both had the LCD or LCD controller on the mainboard listed as possibly bad.

[fromFDMtoSLA]

did you try the exposure test?

[seafreak62]

my apologies. I forgot to put that in.

Yes I did the test and the screen didn't appear to do anything. I could see the LED's below turn on but no patter. I even placed some tracing paper on the screen for better contrast.

[fromFDMtoSLA]

i had the same error - https://www.elegoomars.com/forum/showthread.php?tid=315 - and finally only a new mainboard helped.

[seafreak62]

i had the same error - https://www.elegoomars.com/forum/showthread.php?tid=315 - and finally only a new mainboard helped.

After going over it with ELEGOO Support it was the LCD.  So now have to get a replacement.  With all the shutdowns it is "challenging" to say the least.  Found them in stock at www.filimentone.com and will have it in a few days!