Posts: 1
Threads: 1
Joined: Apr 2020
Reputation:
0
The head goes straight upward and lifts the orange cover off the machine. I have nothing but issues with this thing. I have maybe made about 10 successful prints. Now I cant even get the files to print. I get an immediate Print done error and the head shoots up to the top as fast as it can go..even making a rubbing noise because it seems that it wants to keep going up but there is no more thread left on the xis rods.
Please advise.
Thanks
Joe
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation:
8
04-08-2020, 04:13 AM
(This post was last modified: 04-08-2020, 04:13 AM by fromFDMtoSLA.)
what happend if you move the axis manual?
try a "dry run" without the buildplate and theVAT to check the endstop.
any changes on printer firmware (which one) or slicer (wich one) ?
Posts: 39
Threads: 0
Joined: Feb 2020
Reputation:
3
Sounds like an issue with the zero location. It's trying to go home, but thinks that's way up above.
Make sure it's not losing any steps from slipping/grinding/etc. ( if it is, regrease ), then bring it back down and reset zero.
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation:
8
just checked it out: lifting Z and lifting the cover is done, when i try to print a *.stl-file.
