04-29-2020, 06:52 AM
Printing with Elegoo Water Washable Ceramic Grey
Bottom time 80 sec, layers 8 sec
The piece prints well but the supports dissociate from the top locking arm with some distortion of the arm.
This was reproduced on two subsequent prints.
Support settings and pictures included.
Any thoughts are welcome!
Cheers
Mac
Bottom time 80 sec, layers 8 sec
The piece prints well but the supports dissociate from the top locking arm with some distortion of the arm.
This was reproduced on two subsequent prints.
Support settings and pictures included.
Any thoughts are welcome!
Cheers
Mac