Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Printer Mods / Add-Ons v
25mm fan + active charcoal filter + higher leveling feet

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
25mm fan + active charcoal filter + higher leveling feet
IllDante Offline
Junior Member
**
Posts: 9
Threads: 1
Joined: May 2020
Reputation: 0
#6
05-29-2020, 02:25 PM
Well aware of the adverse effects of changing airflow in a pull system - sure. But, I was asking you - since you installed a filter system, charcoal specifically - why? If the system is not exhausting anything then there is no reason to filter it?
Find
Reply


Messages In This Thread
RE: 25mm fan + active charcoal filter + higher leveling feet - by IllDante - 05-29-2020, 02:25 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)