05-09-2020, 01:19 PM
(05-07-2020, 10:29 PM)fromFDMtoSLA Wrote: watch the moving of the buildplate. If you hear the "Blob" when the buildplate is moving up for the next layer, it is the sound of "stripping off" the last layer from the FEP.
A good indicator that the model is not sticking to the FEP.
I did a little investigating and found that there was somehow moisture trapped under the plate, between the FEP and the glass. Placing a tiny piece of tape on the edge, lifted it just enough to prevent the suction effect. Not sure if this is a permanent viable solution, but I'll be looking into other options.