05-07-2020, 10:19 AM
Hello there,
Second print here - medium sized.
Cleaned the resin tank and re-assembled, realigned and calibrated the plate before beginning new print. Began new print, hearing what sounds like "air bubbles" popping out under pressure.
Is it an issue that there may be air trapped under the resin tank? I only ask as it sounds like this - I cannot confirm unless I skip the print, or wait until it's finished.
Anyone else have experiences with possibility of air bubbles forming under the FEP layer?
Second print here - medium sized.
Cleaned the resin tank and re-assembled, realigned and calibrated the plate before beginning new print. Began new print, hearing what sounds like "air bubbles" popping out under pressure.
Is it an issue that there may be air trapped under the resin tank? I only ask as it sounds like this - I cannot confirm unless I skip the print, or wait until it's finished.
Anyone else have experiences with possibility of air bubbles forming under the FEP layer?