07-06-2020, 05:26 PM
(This post was last modified: 07-06-2020, 05:27 PM by TwiztedShogun.)
I have the Elegoo Mars P. In Chitubox I set my printer to standard model so I can save my file as a .cbddlp. I did this because the Photon File validator doesn't take .ctb files.
I run fix in the validator and save the file. The issue is when I try to import it back into Chitubox. It looks way off. See image attached. Left is before it goes into validator right is when it comes out. I gotta be doing something wrong. Need some help as I'm still new to this. Don't laugh too hard at my support job .
I run fix in the validator and save the file. The issue is when I try to import it back into Chitubox. It looks way off. See image attached. Left is before it goes into validator right is when it comes out. I gotta be doing something wrong. Need some help as I'm still new to this. Don't laugh too hard at my support job .