08-09-2020, 12:07 PM
(This post was last modified: 08-10-2020, 04:34 PM by sujitvasanth.)
I have neen prnting for the last 6 months with isopropyl and without rafts
I use eSun plant based PLA bioresin
the parts are put direct on to the bed with a small cut out wedge at the base where I can wedge a knife in to peel the part off and break the suction
Once the part is removed i wipe it dry with gloves and a paper towel....parts have come out pretty perfect!
no need to wash anything so a lot less rsein waste and no toxic aclohol...
I have been using soy based resin that doesnt irritate the skin and has very little smell (esun epla)
I use eSun plant based PLA bioresin
the parts are put direct on to the bed with a small cut out wedge at the base where I can wedge a knife in to peel the part off and break the suction
Once the part is removed i wipe it dry with gloves and a paper towel....parts have come out pretty perfect!
no need to wash anything so a lot less rsein waste and no toxic aclohol...
I have been using soy based resin that doesnt irritate the skin and has very little smell (esun epla)