11-13-2020, 04:32 AM
I tryed leveling the plate with two sheets.... and even 3.... it doesn't work...
I CANT SET THE ZERO PLATE POSITION!!... it shouldn't be that difficult....
after the calibration I start a print.... the plate goes down...and it pushes too hard apparently... I can hear an awful noise as if the motor is trying to push down and down trying to fing the zero position.... which the printer doesn't seems to record when I calibrate it...
I even noticed that when I tighten the screws that keep the plate in position.... this moves a bit every.. every time... so so frustrating
what am I doing wrong?....
the only 3d file I was able to print is the test elegoo rook file.... not even the minifactory files.... I'ts 3 days and so many attempts... I'm feeling the 3d printer has a problem!
any suggestions? tips and tricks?
does anyone had this happening?
I CANT SET THE ZERO PLATE POSITION!!... it shouldn't be that difficult....
after the calibration I start a print.... the plate goes down...and it pushes too hard apparently... I can hear an awful noise as if the motor is trying to push down and down trying to fing the zero position.... which the printer doesn't seems to record when I calibrate it...
I even noticed that when I tighten the screws that keep the plate in position.... this moves a bit every.. every time... so so frustrating
what am I doing wrong?....
the only 3d file I was able to print is the test elegoo rook file.... not even the minifactory files.... I'ts 3 days and so many attempts... I'm feeling the 3d printer has a problem!
any suggestions? tips and tricks?
does anyone had this happening?