07-18-2019, 03:20 PM
I suspect you are looking to minimize the risk of any "z-wobble" problems.
Because the construction is very similar to the one in Photon orginal, I have also wondered about this. But after reading a lot in the last week about how other users experience their Mars printer, I do not feel worried about "z-wobble". Maybe I only read success stories.
Have you experienced similar Z-wobble problems on your Mars, simulator to that some Photon printers suffer from?
Because the construction is very similar to the one in Photon orginal, I have also wondered about this. But after reading a lot in the last week about how other users experience their Mars printer, I do not feel worried about "z-wobble". Maybe I only read success stories.
Have you experienced similar Z-wobble problems on your Mars, simulator to that some Photon printers suffer from?