|
Linear Rail Upgrade
|
10-13-2019, 09:11 AM
(07-22-2019, 10:53 AM)Frameone Wrote: I would suspect this is only for printers that have a Z-wobble problem. I cannot discern the layer lines in my prints! I can see a wobble at the top of the z axis screw. Is this normal? I haven't seen any issues with prints, but my typical product is not very tall. I am wondering if the z-axis is bent. Comments? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Linear Rail Upgrade - by obv - 07-18-2019, 02:25 PM
RE: Linear Rail Upgrade - by MrAsh - 07-18-2019, 03:20 PM
RE: Linear Rail Upgrade - by obv - 07-19-2019, 05:09 AM
RE: Linear Rail Upgrade - by Frameone - 07-22-2019, 10:53 AM
RE: Linear Rail Upgrade - by whitman411@yahoo.com - 10-13-2019, 09:11 AM
RE: Linear Rail Upgrade - by MikeRD03 - 10-18-2019, 09:29 AM
RE: Linear Rail Upgrade - by Gauntfield - 07-03-2020, 10:06 PM
RE: Linear Rail Upgrade - by cliffyk - 07-04-2020, 03:13 PM
RE: Linear Rail Upgrade - by fromFDMtoSLA - 07-05-2020, 01:00 AM
|
