01-18-2021, 11:30 AM
I have an Elegoo Mars (m08) that has worked great for the last year. I recently traveled to another state and brought it with me. Once I arrived and began trying to print on it, the printer shuts down somewhere between the first and fifth layer every time. I tried updating the firmware, changing the motor out and replacing the limiter switch, but nothing has changed. Everything works exactly as it should. Zeroing out, esposure test, the arm moves fully up and down the threaded rod.
It always happens in the beginning layers where it beeps each time with the plate being at zero, so it never makes it to the "non-beep" layers. It always immediately powers on after shutting down as well.
Everything seems to be in perfect order and I cannot figure out why it is doing this.
Below is a video of the printer doing this.
It always happens in the beginning layers where it beeps each time with the plate being at zero, so it never makes it to the "non-beep" layers. It always immediately powers on after shutting down as well.
Everything seems to be in perfect order and I cannot figure out why it is doing this.
Below is a video of the printer doing this.