03-04-2021, 10:46 AM
If you print large objects - means in XY-Large then you can see the z-Axis is bending if the model stick to strong on the FEP.
I use silikon-grease o the FEP-Film and also see bending - so i have developed a simple solution to stabilize the Z-Axis. I have send it to elegoo and they found this a good solution.
I use silikon-grease o the FEP-Film and also see bending - so i have developed a simple solution to stabilize the Z-Axis. I have send it to elegoo and they found this a good solution.