06-27-2021, 04:10 PM
I have been plagued with problems getting my bed leveled, but the other day I seem to had it dialed in just right. Then I had some problems with supports I guess as parts og my prints were coming out flat. Now for some reason my bed won't relevel.
I put a piece of paper down on the screen, loosen both build plate bolts, hit the button lot lower the plate down, use the paper to align the plate to the screen, tighten front bolt, then side bolt, but then when I try to adjust the plate down 0.1mm at a time till it grabs the paper and holds it, it never does. No matter how many times I press down, it simply will not go down enough to grab the paper so that can start coming up to where it will let it go enough to get the plate at the right height and readjust the zero setting. Please help I am loosing my mind.
All settings are factory standard except for lift speeds which I changed to 55
I put a piece of paper down on the screen, loosen both build plate bolts, hit the button lot lower the plate down, use the paper to align the plate to the screen, tighten front bolt, then side bolt, but then when I try to adjust the plate down 0.1mm at a time till it grabs the paper and holds it, it never does. No matter how many times I press down, it simply will not go down enough to grab the paper so that can start coming up to where it will let it go enough to get the plate at the right height and readjust the zero setting. Please help I am loosing my mind.
All settings are factory standard except for lift speeds which I changed to 55