Thread Rating:
  • 0 Vote(s) - 0 Average
FEP Scarring
#1
I went to clean my FEP for the first time after my first few prints and I noticed that there was some slight "scaring" from the second print I did which was a fin unit for a model rocket.  You can see the outline from one of the middle layers (I can tell it was a middle layer by the shape).  The scarring (if you look really close) manifests as tiny blisters or bumps on the FEP.

I didn't see any scarring from any of the other prints I did and it did not seem to negatively affect the subsequent prints although they may not have been in contact with that part of the FEP.

Is this normal or is it cause for concern?  This is my first 3D printer so I have no idea what is considered normal wear so I thought I would post the question to see if anyone else has experienced this.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)