Saturn Z axis calibration

[EmeryJ]

Confirmed.  Step 1 version is temporary until power down.  Once machine is turned back on, this procedure must be done again.

Step 2 version is permanent.  Changing the Gcode will make this happen every time you fire up the machine.

To recap.  My cube measured 19.55.  I set 8084 Z-0.45
Printed the Gcode file to my Saturn.
Powered down and back up again.
Loaded my cube print file.
Printed.
Came out 20.00 on Z axis.
Perfect!!

Thank you to those who steered me in the right direction for this fix!!
It is flawless.