Mars p2

[tempsdental]

New here. Was wondering if some one could explain to me why a test cube 200x200x200 prints larger than the design?  After printing the Z = 203 X =217 Y =216 Doesn't seem to be very accurate.  Is this common with this machine? Mars 2p 

Thank you

[mzanetti]

Hi, I suppse you meant 20x20x20... Anyhow, while mine (also 2P) is also not 100% accurate, it still seems to be much better. Just measured the cube and it's 20,00 x 20,20 x 20,19 which seems pretty good to me.

Not sure what might cause this for you though... Perhaps wrong profile in the slicer software? I am using LycheeSlicer.