print failure solved

[Arjan]

I did report my problem to Elegoo, They analysed it was the LCD screen an sent me a new one. With som online help of them I dis install it. Everything works fine again. I am impressed with their service!



i, My name is Arjan from the Netherlands. Got my Saturn a few weeks ago and made some fine prints like the bike shown on picture (measurements in cm) So initially I was enchanted. But since a few days I got a nasty problem which I can not explain at all All my prints are just one big mesh. See attached photos failure 1b and failure 2b. Anyone who has a clou and a solution for what is going on? Greetings, Arjan

[mzanetti]

I once had a print that looked like this. Turned out I used too short curing times for that particular resin. But I suppose you're probably still using the same settings as you did with the bike print, so that's probably not it...

Are you shaking the resin bottle before using?