07-21-2021, 12:45 PM
Afternoon all! I recently got my Mars 2 and everything ran smoothly as far as setup and test prints. I then went on to print for almost 12 hours straight with no issues. I attempted to print something today and now I get a groaning sound ONLY when I attempt to print. I have emptied the vat, greased the guide rode and leveled the bed at least 9 times. I tried doing a test print without the vat and everything seemed to go fine...the issue ONLY OCCURS when the vat is in place and attempting to print. The platen doesn't drop all the way into the vat either I should mention. Any thoughts on what to do next?