08-03-2021, 07:21 AM
Hi all.
Just got my printer set up,
Tried to print the rook but it stuck to the bottom if the resin tray (looks like this is a common problem).
I've tried to print another model but I'm getting a message saying unknown file type.
It's a chitubox CTP file, just like the rook, but won't open.
Any ideas?
Just got my printer set up,
Tried to print the rook but it stuck to the bottom if the resin tray (looks like this is a common problem).
I've tried to print another model but I'm getting a message saying unknown file type.
It's a chitubox CTP file, just like the rook, but won't open.
Any ideas?