07-27-2021, 01:59 AM
Hi All,
I hope I am in the right place for this......
I have just downloaded the latest version of Chitubox and it told me I needed to update the firmware in my Mars Pro.
I followed all the steps, everything seemed to work, I had a series of beeps after I had installed the three files. They were done in the order as it said on the elegoo website.
However, when I press home, the build plate moves up, not down. I looked at a video of how to set the home position but it does not seem to want to work.....
Please could someone offer me some guidance?
I hope I am in the right place for this......
I have just downloaded the latest version of Chitubox and it told me I needed to update the firmware in my Mars Pro.
I followed all the steps, everything seemed to work, I had a series of beeps after I had installed the three files. They were done in the order as it said on the elegoo website.
However, when I press home, the build plate moves up, not down. I looked at a video of how to set the home position but it does not seem to want to work.....
Please could someone offer me some guidance?