+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Elegoo Mars 3 touchscreen unresponsive after calibration (/showthread.php?tid=1116)
Elegoo Mars 3 touchscreen unresponsive after calibration - Triandin - 03-26-2022
Hi, I calibrated the screen with the specific option and the monitor no longer responds to touch. I tried to turn it off and on again but nothing. The printer is new, it only made 8 prints.
Please help,
Daniele
RE: Elegoo Mars 3 touchscreen unresponsive after calibration - evilned - 04-15-2022
(03-26-2022, 11:11 AM)Triandin Wrote: Hi, I calibrated the screen with the specific option and the monitor no longer responds to touch. I tried to turn it off and on again but nothing. The printer is new, it only made 8 prints.
Please help,
Daniele
(04-15-2022, 02:12 AM)evilned Wrote:(03-26-2022, 11:11 AM)Triandin Wrote: Hi, I calibrated the screen with the specific option and the monitor no longer responds to touch. I tried to turn it off and on again but nothing. The printer is new, it only made 8 prints.
Please help,
Daniele
Hi mate, I know this is probably a little late for you. But I'll post the answer that fixed your problem when I encountered it.
I contacted elegoo support and they got back to me straight away with the solution below.
Hope this helps future people searching for a solution to this problem.
Very sorry for the late reply.
Please download the file linked below to the root directory of the U disk, then insert the U disk into the machine, and restart the machine, the machine will automatically update.
https://drive.google.com/file/d/1emA3l1cm-WvRdDYEePXQ4BRynV6KJC1v/view?usp=sharing
If the touch screen works, please update the firmware at the link below.
https://drive.google.com/file/d/1VykWL9Dq_oNUYf1TrWVPaknkvHxnuZHC/view?usp=sharing