+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: flattening and cavities in prints (/showthread.php?tid=1131)
flattening and cavities in prints - hotcoppersky - 05-07-2022
I just started printing with a Mars 3. Most of my prints turn out fine, but I have had a couple that seem to have cavities and flattening in the prints. I'm using Grey ABS-Like Elegoo resin. If any of the pros on here can assist, that would be much, much appreciated. I've included a picture of the issue as well as my slicer parameters. I checked over the stl models and they don't seem to be the issue. Any help is welcomed.