05-07-2022, 02:56 PM
(This post was last modified: 05-07-2022, 03:05 PM by hotcoppersky.)
I just started printing with a Mars 3. Most of my prints turn out fine, but I have had a couple that seem to have cavities and flattening in the prints. I'm using Grey ABS-Like Elegoo resin. If any of the pros on here can assist, that would be much, much appreciated. I've included a picture of the issue as well as my slicer parameters. I checked over the stl models and they don't seem to be the issue. Any help is welcomed.