Build plate un-leveling before 1% - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 2 Pro (https://www.elegoomars.com/forum/forumdisplay.php?fid=46) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=50) +--- Thread: Build plate un-leveling before 1% (/showthread.php?tid=1247)

Build plate un-leveling before 1% - Raynx - 10-13-2022 I've been using my Mars 2 Pro for a few months now and have just recently had this issue. As the attachment shows the build head goes off balance usually before even 1% of the build is done. This happens after following the correct procedure for levelling the build plate, and the build plate is visibly level before entering the resin.  So far I have tried: Setting the build plate screws tightly when leveling Setting the build plate screws only finger tight when leveling Checking that the printer is level (it is) Replacing the FEP (in case one side was sticking more than the other But so far 6 different trials and retrials come to the same end - the build plate goes in the resin level, then comes out at or after 1% very much un-levelled. For what it is worth the screws holding the build plate have been tight or loose in different trials, but all to the same result. Having trouble finding a solution so any help is appreciated