10-13-2022, 12:55 PM
I've been using my Mars 2 Pro for a few months now and have just recently had this issue.
As the attachment shows the build head goes off balance usually before even 1% of the build is done. This happens after following the correct procedure for levelling the build plate, and the build plate is visibly level before entering the resin.
So far I have tried:
Having trouble finding a solution so any help is appreciated
As the attachment shows the build head goes off balance usually before even 1% of the build is done. This happens after following the correct procedure for levelling the build plate, and the build plate is visibly level before entering the resin.
So far I have tried:
- Setting the build plate screws tightly when leveling
- Setting the build plate screws only finger tight when leveling
- Checking that the printer is level (it is)
- Replacing the FEP (in case one side was sticking more than the other
Having trouble finding a solution so any help is appreciated