+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8)
+--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11)
+--- Thread: Model sink? (/showthread.php?tid=136)
Model sink? - CollinsA - 09-18-2019
In the image what causes the model to sink or pull away from the supports? I get this every so often and cannot seem to figure out what would cause it. This seems to also be a cause of failed prints. Any insights would be great.
Thanks
RE: Model sink? - admin - 09-19-2019
This is usually related to supports. Either not enough or the contact point isn't big enough. It's suggested to always use large supports too.
RE: Model sink? - CollinsA - 09-19-2019
admin Wrote:This is usually related to supports. Either not enough or the contact point isn't big enough. It's suggested to always use large supports too.Ok thank you