In the image what causes the model to sink or pull away from the supports? I get this every so often and cannot seem to figure out what would cause it. This seems to also be a cause of failed prints. Any insights would be great.
Thanks
Thanks
Model sink?
|
In the image what causes the model to sink or pull away from the supports? I get this every so often and cannot seem to figure out what would cause it. This seems to also be a cause of failed prints. Any insights would be great.
Thanks
09-19-2019, 02:01 AM
This is usually related to supports. Either not enough or the contact point isn't big enough. It's suggested to always use large supports too.
09-19-2019, 07:50 AM
admin Wrote:This is usually related to supports. Either not enough or the contact point isn't big enough. It's suggested to always use large supports too.Ok thank you |
« Next Oldest | Next Newest »
|