NOISE IN THE AXIS Z - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=8) +--- Forum: General Troubleshooting (https://www.elegoomars.com/forum/forumdisplay.php?fid=11) +--- Thread: NOISE IN THE AXIS Z (/showthread.php?tid=368) |
NOISE IN THE AXIS Z - jorge polo - 02-09-2020 Has anyone experienced noise when moving the z axis during printing? When I go up and down manually there is no noise. Es un ruido similar a un salto, y solo ocurre en una sección del huso Gracias por su apoyo RE: NOISE IN THE AXIS Z - fromFDMtoSLA - 02-09-2020 wrong speed in the print-settings? attached my settings and i got same noise as manual movement if it sound's like a "plop", it is the sound of removing the actual layer from the FEP RE: NOISE IN THE AXIS Z - jorge polo - 02-09-2020 (02-09-2020, 05:58 AM)jorge polo Wrote: ¿Alguien ha experimentado ruido al mover el eje z durante la impresión? Cuando subo y bajo manualmente no hay ruido.thanks for your quick response. I see that I have the same configuration as the one you attached. I am too new to understand what you say about eliminating the actual FEP layer. Can you tell me that I have to change? Thank you so much for your patience RE: NOISE IN THE AXIS Z - fromFDMtoSLA - 02-09-2020 nothing to change, if it is only the "plop"-sound. just in a hurry, will come back later |