Still failing - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1) +--- Forum: Maintenance & How-To (https://www.elegoomars.com/forum/forumdisplay.php?fid=10) +--- Thread: Still failing (/showthread.php?tid=582)

Still failing - VonStrom - 08-07-2020 Ok Replaced the LCD screen and still have failing prints.  releveled the print bed. have used masking tape, ptfe lube.... Im at a loss. I printed fine for 6 weeks after last screen went in and now I cant print anything successfully RE: Still failing - cliffyk - 08-07-2020 What is the failure mode, holes, "melting", deformation? To test the entire screen using this 68 x 120 x 2 mm "block", do a dry run "printing" of the block with the vat and platen removed--it will reveal any defects in the entire screen, not just the perimeter: ThIs is what my last failed LCD shutter (wIth < 250 hours on it) looked like, through a sheet of paper while "printing" the block: RE: Still failing - VonStrom - 08-09-2020 I can not post reply pics cause I keep getting file too large.....