+- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum)
+-- Forum: Elegoo Mars 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=1)
+--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=2)
+--- Thread: Check Printer setting on Chitubox startup! (/showthread.php?tid=8)
Check Printer setting on Chitubox startup! - JoePeacock - 07-18-2019
BE SURE that when you open Chituboxthat you check under setting that you have the Elegoo Mars set as the printer. If you don't everything will come out skewed and wonky jawed.
RE: Check Printer setting on Chitubox startup! - CollinsA - 09-06-2019
JoePeacock Wrote:BE SURE that when you open Chituboxthat you check under setting that you have the Elegoo Mars set as the printer. If you don't everything will come out skewed and wonky jawed.Joe,
Running V1.5.0 and under settings for machine type there is no option for selection. mine is simply set to (default) This applies to the name as well. Any ideas?
Thanks
RE: Check Printer setting on Chitubox startup! - MarkE - 09-07-2019
(09-06-2019, 06:50 AM)CollinsA Wrote: Running V1.5.0 and under settings for machine type there is no option for selection. mine is simply set to (default) This applies to the name as well. Any ideas?
Left hand side of the Settings page, above where it says Default, there's a button to add a new printer. Click this and pick Elegoo Mars from the list to create a new machine, which will now appear underneath the Default printer.