First print issues (noob) - Printable Version +- Elegoo 3D Printers Forum (https://www.elegoomars.com/forum) +-- Forum: Elegoo Saturn 4K / 8K 3D Printer (https://www.elegoomars.com/forum/forumdisplay.php?fid=51) +--- Forum: Getting Started (https://www.elegoomars.com/forum/forumdisplay.php?fid=52) +--- Thread: First print issues (noob) (/showthread.php?tid=864)

First print issues (noob) - icodeforlove - 06-29-2021 I just got the Elegoo Saturn, and setup the printer. (3d resin printer noob) I printed with the standard settings, and ran into a few issues. On the base of one it didn't seem to attach, I assume it was because the bed was not level enough. The bigger issue is i noticed some layers splitting on both prints on both sides. I also noticed the base was a bit discolored, and pale looking. I'm hoping someone more experienced with 3d printers can give me a little advice. RE: First print issues (noob) - Diamond999 - 09-21-2022 I would recommend leveling your print plate then re-slicing the files in Chitubox rotated 45 degrees on the X and Y axis then add supports. You can download the rook file here: https://www.thingiverse.com/thing:3962430 Rotating 45 degrees on the X and Y axis is a thing I always do and it greatly improves print quality.