06-29-2021, 02:38 PM
(This post was last modified: 06-29-2021, 02:42 PM by icodeforlove.)
I just got the Elegoo Saturn, and setup the printer. (3d resin printer noob)
I printed with the standard settings, and ran into a few issues.
I printed with the standard settings, and ran into a few issues.
- On the base of one it didn't seem to attach, I assume it was because the bed was not level enough.
- The bigger issue is i noticed some layers splitting on both prints on both sides.
- I also noticed the base was a bit discolored, and pale looking.