| Reputation Report for cliffyk | ||||||||||||||||||||||
| Summary | ||||||||||||||||||||||
|
||||||||||||||||||||||
| Comments | ||||||||||||||||||||||
|
coaxfun (
0
) - Last updated 01-15-2022, 09:45 PM Rating given for cliffyk's post in Setting Z Offset Not Working Right... Positive (+1): [No comment] |
||||||||||||||||||||||
|
coaxfun (
0
) - Last updated 01-15-2022, 09:45 PM Rating given for cliffyk's post in Setting Z Offset Not Working Right... Positive (+1): [No comment] |
||||||||||||||||||||||
|
coaxfun (
0
) - Last updated 01-15-2022, 09:45 PM Rating given for cliffyk's post in Setting Z Offset Not Working Right... Positive (+1): [No comment] |
||||||||||||||||||||||
|
coaxfun (
0
) - Last updated 01-15-2022, 09:45 PM Rating given for cliffyk's post in Setting Z Offset Not Working Right... Positive (+1): [No comment] |
||||||||||||||||||||||
|
billtodd (
0
) - Last updated 01-02-2022, 01:03 PM Rating given for cliffyk's post in Build plate now lifts off FEP on Initial Layer?? Positive (+1): [No comment] |
||||||||||||||||||||||
|
improbablegarage (
0
) - Last updated 03-02-2021, 06:00 AM Negative (-1): a misogynist |
||||||||||||||||||||||
|
torytrae (
0
) - Last updated 02-19-2021, 05:38 PM Rating given for cliffyk's post in Resin on LCD Positive (+1): [No comment] |
||||||||||||||||||||||
|
Gerrib (
0
) - Last updated 02-13-2021, 02:55 AM Rating given for cliffyk's post in Problem with supports not printing Positive (+1): [No comment] |
||||||||||||||||||||||
|
torytrae (
0
) - Last updated 02-07-2021, 07:05 AM Rating given for cliffyk's post in Problem with supports not printing Positive (+1): [No comment] |
||||||||||||||||||||||
|
torytrae (
0
) - Last updated 02-07-2021, 07:05 AM Rating given for cliffyk's post in Problem with supports not printing Positive (+1): [No comment] |
||||||||||||||||||||||
|
torytrae (
0
) - Last updated 02-07-2021, 07:05 AM Rating given for cliffyk's post in Problem with supports not printing Positive (+1): [No comment] |
||||||||||||||||||||||
|
torytrae (
0
) - Last updated 02-07-2021, 07:05 AM Rating given for cliffyk's post in Problem with supports not printing Positive (+1): [No comment] |
||||||||||||||||||||||
|
Chri5 (
0
) - Last updated 01-31-2021, 01:31 PM Rating given for cliffyk's post in Using flex plates: my lessons learned Positive (+1): Your welcome! Was fun writing it and to pimp my printer too=) |
||||||||||||||||||||||
|
Misterjeff (
0
) - Last updated 01-19-2021, 12:18 PM Rating given for cliffyk's post in Do I need to update firmware? Positive (+1): [No comment] |
||||||||||||||||||||||
|
wolfloner (
0
) - Last updated 01-04-2021, 12:03 PM Rating given for cliffyk's post in Burr, sag or something like that Positive (+1): [No comment] |
||||||||||||||||||||||