08-22-2021, 02:36 AM
Hi All,
I have recently updated my firmware to run Chitubox v1.9.0 and the quality is not as good.
I am seeing steps and lines in parts that were simply invisible in the previous versions . I'm not sure where to start looking for the problem , but my first suspition is chitubox's alias settings (does anyone know what the 1.8 v settings were?) - incidently the new CB has a bad habit of crashing when switching back to 'part placement' from 'support' mode !
Suggestions?
TIA
Bill
I have recently updated my firmware to run Chitubox v1.9.0 and the quality is not as good.
I am seeing steps and lines in parts that were simply invisible in the previous versions . I'm not sure where to start looking for the problem , but my first suspition is chitubox's alias settings (does anyone know what the 1.8 v settings were?) - incidently the new CB has a bad habit of crashing when switching back to 'part placement' from 'support' mode !
Suggestions?
TIA
Bill