02-08-2022, 04:46 PM
(02-08-2022, 04:23 PM)cliffyk Wrote: That is exactly how I do it...Thanks for all your help Cliff. Will keep in touch.
However the needed correction will be affected by overall volume and relative X, Y, Z dimensions as the "tiny mushy bricks" pile up--any "average" correction will be just a good place to start based on experience and what your gut tells you.
Keep in mind that while the Z-axis resolution for your Saturn is variable in 0.00125 mm (1.25 micron) increments via layer height, X & Y maximum resolution is fixed by the LCD pixel size (0.05 mm, 50 microns).
Actual print dimensions (even if 100% accurate) will always be multiples of those maximum resolutions.
Keep in touch and let us know how things are going...