Hi
I have an Elegoo Mars and i am having some really strange goings on
just printed out 3 flat bottomed open topped simple cubes, one its printed correctly the other two have not got flat bottoms they are curved to one side and you can see each individual layer. The bottom layer printed about 30% then the next one about 32% and so on giving a sloped appearance. this is with the water resin.
I am finding with the ordinary resin that the models tend to stick to the film.
I have just installed a new light and two new resin tanks,but i still cannot get a reliable print out of the thing
Many thanks
Sandra
ps it worked fine for months not it doesnt
I have an Elegoo Mars and i am having some really strange goings on
just printed out 3 flat bottomed open topped simple cubes, one its printed correctly the other two have not got flat bottoms they are curved to one side and you can see each individual layer. The bottom layer printed about 30% then the next one about 32% and so on giving a sloped appearance. this is with the water resin.
I am finding with the ordinary resin that the models tend to stick to the film.
I have just installed a new light and two new resin tanks,but i still cannot get a reliable print out of the thing
Many thanks
Sandra
ps it worked fine for months not it doesnt